The Interface Gas Pressure Leak Tester, Model GPL-5020, is designed for rapid, non-destructive testing of catheters. Its modular construction allows for expanding the number of test ports from one to twenty, in multiples of five. Each test port is fitted with a small isolation solenoid valve, allowing each catheter to be tested independently. The system can also perform vacuum leak testing of catheter/stent assemblies to verify the integrity of a balloon after stent crimping.
Key Features
- Modular design, up to 20 test ports
- Auto-calibration & Rapid test sequence
- Air activated Touhy-Borst ports or Luer ports
- Stores up to 100 programmable sequences
- Leak test in less than 4 seconds
- 2 Leak rate, compliance and flow resistance testing
Technical Specs
| Power Requirements: | Electrical: 100/110/220/240 VAC, 50-60Hz 120W plus 20W per manifold module Test Media: Dry nitrogen @ 525psi (3.5 MPa) Shop Air: Dry filtered Air @ 100-150psi (0.7-1.0MPa) |
| Size: | 67”H X 31”W X 31”D (170cmH X 79cmW X 79cmD) |
| Weight: | Complete system with stand and two manifold modules: 56lbs (25.5kg), each additional module: 9.0lbs (4.1kg) |
| Pressure Accuracy: | ± 0.5% of full scale |
| Pressure Resolution: | 0.03psi (68.9Pa) |
| Maximum Test Pressure: | 500psi (3.5MPa) |
| Maximum Vacuum Level | 26” Hg (660 mm Hg) |
| Leak Rate Sensitivity: | 0.300 psi/min * |
| Capacity: | 1 to 20 test ports (5 test ports per manifold module) |
| Serial Port: | 9-Pin, PC compatible |
| Parallel Printer Port: | PC compatible |
