Continue
Your
Search

Gas Pressure Leak Tester: GPL-5020

The Interface Gas Pressure Leak Tester, Model GPL-5020, is designed for rapid, non-destructive testing of catheters. Its modular construction allows for expanding the number of test ports from one to twenty, in multiples of five. Each test port is fitted with a small isolation solenoid valve, allowing each catheter to be tested independently. The system can also perform vacuum leak testing of catheter/stent assemblies to verify the integrity of a balloon after stent crimping.

Key Features

  • Modular design, up to 20 test ports
  • Auto-calibration & Rapid test sequence
  • Air activated Touhy-Borst ports or Luer ports
  • Stores up to 100 programmable sequences
  • Leak test in less than 4 seconds
  • 2 Leak rate, compliance and flow resistance testing

Technical Specs

Power
Requirements:
Electrical: 100/110/220/240 VAC, 50-60Hz 120W plus 20W per manifold module
Test Media: Dry nitrogen @ 525psi (3.5 MPa)
Shop Air: Dry filtered Air @ 100-150psi (0.7-1.0MPa)
Size:67”H X 31”W X 31”D
(170cmH X 79cmW X 79cmD)
Weight:Complete system with stand and two manifold modules: 56lbs (25.5kg), each additional module: 9.0lbs (4.1kg)
Pressure
Accuracy:
± 0.5% of full scale
Pressure
Resolution:
0.03psi (68.9Pa)
Maximum Test
Pressure:
500psi (3.5MPa)
Maximum Vacuum
Level
26” Hg (660 mm Hg)
Leak Rate
Sensitivity:
0.300 psi/min *
Capacity:1 to 20 test ports
(5 test ports per manifold module)
Serial Port:9-Pin, PC compatible
Parallel Printer
Port:
PC compatible