Electrochemical Cutting & Grinding as an Alternative to Laser Cutting | Tridex CS1-E

Challenge

A high-powered laser beam cuts the tubing by melting it, leaving a rough edge and slag. Tubes and other parts are typically cut one at a time, limiting production rates.

Laser cutting has several limitations for tube cutting applications, especially when heat sensitivity is a concern. The process leaves recast layers and heat-affected zones that compromise tube quality and drive up scrap rates. Beam deflection when cutting through a tube can further reduce dimensional accuracy and cause unintended part damage. Laser cutting also can’t produce clean, sharp edges, making time-consuming secondary deburring and debris removal unavoidable.

The challenge was to develop a tube-cutting process that consistently delivers precise, clean cuts to length, with no recast, no slag, and no heat-affected zones, while improving production times and eliminating the need for secondary operations.

 

Process

The Tridex CS1-E Burr-Free Electrochemical Cutoff Machine (ECG) provides a precise, efficient solution for cutting metal tubes to length, while the Tridex SG-1645 and SG-2060 Electrochemical Surface Grinders address secondary operations such as notching, bevel grinds, and multi-facet points, all within the same production workflow.

Electrochemical cutting and grinding deliver fast, accurate, burr-free results with no heat-affected zones, metallurgical damage, distortion, or debris after rinsing. The CS1-E features a highly precise feed system accurate to 0.0004 inch (0.01 mm), and Tridex ECG machines can perform cutoff and notching in a single pass. An optional pallet index table on the SG series machines enables continuous high-volume grinding without interrupting production to load and unload parts.

Eliminating burrs removes the need for secondary deburring operations, reducing scrap and improving overall efficiency. The ECG process’s very low cutting forces make it particularly well suited for tubing and heat-sensitive alloys. Multiple tubes can be cut simultaneously; for example, 89 hypotubes at 25G (0.020 inches diameter) are cut in a single 20-second cycle, or 0.23 seconds per piece, compared to about 2 seconds per piece with laser cutting.

Excellent wheel life and low consumable costs make electrochemical cutting and grinding a cost-effective, high-production solution. Intuitive software and controls simplify setup and operation, while integrated shop floor data collection supports OEE monitoring and process analysis.

Contact an Engineer

Solution: Tridex CS1-E Burr-Free Electrochemical Cutoff Machine

The Tridex CS1-E Burr-Free Electrochemical (ECG) Cutoff Machine cuts burr-free, virtually eliminating the need for deburring and other corrective secondary operations while reducing scrap. ECG can cut almost all metals burr-free, making it an attractive option for cutting medical tubing. To increase efficiency, the CS1-E can cut multiple bars or tubes per cycle, limited only by part diameter.